Ohaus CD-33 Indicator Manuel d'utilisateur télécharger pdf (Page 36)

CD Indicators

4.3 Percent Weighing

Percent Weighing is

enabled only

when Percent is turned ON in the Mode submenu under Setup. Percent weighing

permits you to place a reference load on the pan; then view other loads as a percentage of the reference. The load you

place on the pan as a reference may be displayed as any percentage you select from 5% to 100% (in 1% increments).

100% does not necessarily have to represent the reference load. Subsequent loads, displayed as a percentage of the

reference are limited only by the capacity of the scale base. The default setting is Reference 100%. Refer to para-

graph 3.8 to enable percent weighing.

Procedure

• Press the Mode button, WEIGH is displayed.

• Press or button until PERCENT is dis-

played.

• Press Enter button, PUT>PAN 100% or whatever was

set last time is displayed. If a container is used, the

Indicator can be tared at this point. The % display

momentarily blanks while the Indicator is taring out.

• Put the reference load on the pan.

• Press or button and select reference

weight percentage (Percent Range 5 to 100). Hold

button down for fast change.

• Press Enter button to save setting, WORKING is

displayed ... calculating reference weight. Indicator

displays reference weight for 5 seconds in selected

measuring unit, then displays the percentage.

• Remove the reference weight from the pan and re-

place it with another load. The second load is dis-

played as a percentage of the reference. Container

can be tared anytime during operation: container on

scale, press Tare button. When Tare was entered,

display always shows NET weight (G/N/T button

disabled).

NOTE: The PERCENT display (number of digits) is a

function of the accuracy of the Indicator and the size of

the reference weight. The display examples were with a

2kg mass used with an 40kg scale base.

(Tare was entered)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 46 47

Pas de commentaire

Ohaus CD-33 Indicator Manuel d'utilisateur Page 36